Answer:
To select and choose the correct comm port that your stand is connected to, go to System Settings > Comm settings (See below)
Checking Com settings in Emperor xt
How do I Check or select a comm port in Emperor-xt?
Related questions
Related docs
Manual
-
MultiTest-dV Bancs d’essai de Traction/Compression Mode d'emploi
-
MultiTest-dV Tension and Compression Test Stand Operating Manual
MultiTest-dV Tension and Compression Test Stand Operating Manual
-
Installation and Operation of Mecmesin Interlocked Machine Guarding
Certificate
-
Certificate of Product Conformance - Mecmesin software (Emperor and VectorPro)
-
Declaration de Conformite CE, MultiTest 10-i; 25-i; 50-i; MultiTest 10-xt; 25-xt; 50-xt et Carter de protection
-
Declaration de Conformite CE, MultiTest 0.5-i; 1-i; 2.5-i; 5-i; MultiTest 05.-xt; 1-xt; 2.5-xt; 5-xt; FPT-H1-i; FPT-H1-xt et Carter de protection
-
Declaration de Conformite CE, Carter de protection 2.5, Carter de protection 0.5 et Carter de protection 1.0
Guide
-
Installing Emperor 1.18-408 Software
To install Emperor 1.18-408 software right click and run the Emperor setup.exe file as administrator and then follow the on-screen prompts.
-
Connecting an AFTI or AFG to Emperor Lite software
This guide describes the setup of AFTI and AFG gauges in conjunction with logging the raw data in Emperor Lite.
-
Emperor Crystal Reports Error
This guide describes how to resolve the problem with the Emperor Reporter where reports are not generated successfully.